Antenna Wires, Repairing
Contact Housings and Connectors, Repair InformationValve, Removing and Installing, Metal Valve
Special tools and workshop equipment
required
Torque Wrench -VAG1410-
Perform the Following:
Removing
–
Remove the Tire Pressure Monitoring Sensor. Refer to
...
Flat Connector Systems
Note
If necessary, housing securing mechanisms (secondary locks)
must be released or removed using specified tool before
releasing the contacts. Refer to
→ Chapter „Secondary Lock“.
...
Contaminants Removed from Refrigerant Circuit
The reservoir/receiver/dryer or dryer bag/cartridge should
not be replaced under the following conditions.
After an accident when there is no damage on the
reservoir/receiver/dryer.
The repair was done quickl ...