Volkswagen Polo Owners Manual: Switching the TCS on and off
Fig. 116 In the centre console: button for switching the TCS on and off manually
First read and observe the introductory information
and safety warnings The electronic stability control (ESC) only functions when the engine is running. It consists of ABS, EDL and TCS.
When the engine is running, the TCS can be switched off by pressing the
button . The TCS should
only be switched off in certain situations when the traction achieved is not sufficient.
For example:
- When driving in deep snow or on loose surfaces.
- When rocking the vehicle backwards and forwards to free it from mud.
Then press the
button to switch the TCS back on.
Brake support systems
First read and observe the introductory information
and safety warnings The brake support systems ESC, ABS, BAS,
TCS and EDL only function when the engine is running. They make a considerable co ...
Brake fluid
Fig. 117 In the engine compartment: cap
on the brake fluid container
First read and observe the introductory information
and safety warnings Brake fluid will gradually absorb water
from the ...
Other materials:
Trailer Socket
Connect the trailer socket to the vehicle electrical system
of the vehicle pulling the trailer according to the manufacturer
instructions.
Refer to the applicable wiring diagrams or manufacturer
installation instructions when installing ...
Introduction
This chapter contains information on the following subjects:
→ Warning lamp
→ Childproof lock
Additional information and warnings:
Exterior views
Vehicle key set
Central locking system
Manual opening and closing
WARNING
Any door that is not properly ...
Checklist
Carry out the steps in the specified order :
With the engine at operating temperature,
park the vehicle on a level surface to ensure that the engine oil reading is
correct.
Switch off the engine and wait a few minutes
for the engine oil to flow back into the sump.
Open the ...
