IntroductionWheel, Balancing, Tire and Wheel Radial and Lateral Run-Out, Checking
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
Wheel Bolt Versions
Shank Designs
There are two shank designs: rounded and conical.
The rounded shank has a curved surface
-arrow A-. This design was used for original rims.
The conic ...
Coolant Fan Control Module -J293
Note
Available in different construction styles, some installed
on coolant fan -arrows-.
This control module switches on and off the A/C clutch and
therefore the A/C compressor. It switche ...