VW Polo manuals

Volkswagen Polo Service & Repair Manual: General Information

Perform a road test to determine if a vehicle pulls to one side and if so, when and to which side. If the vehicle pulls to one side. Refer to → Chapter „Corrective Action When Vehicle Pulls to One Side“.
If the vehicle alignment is measured, submit the measurement printout and the complaint report with the tire.
Manufacturer's tolerances can lead to taper in the tire construction. This results in a side force when the tire rolls, which acts directly on the suspension and can therefore lead to vehicle self-steering behavior. Targeted rotation of the wheels can balance out this self-steering behavior.
   
Vehicle Pulls to One Side
...

Taper
Taper is caused by slightly offsetting the tread and/or the belt by a few tenths of a millimeter from the geometric center of the tire. Taper cannot be recognized vis ...

Other materials:

EU Tire Label, Goals
To reduce fuel usage To improve road safety To reduce traffic noise The EU Tire Label Provides the End-User with Information About the Tire's Most Important Properties. However, it Does ...

Lifting the vehicle with the jack
Fig. 168 Jacking points for the vehicle jack (mirrored on the right-hand side of the vehicle) Fig. 169 Vehicle jack at the rear left-hand side of the vehicle First read and observe the introductory information and safety warnings The jack may be applied only at the jacking points shown (m ...

Changing a blown fuse
Fig. 174 A blown fuse Fig. 175 Removing or fitting a fuse using the plastic pliers ① First read and observe the introductory information and safety warnings Preparation Switch off the ignition, the lights and all electrical consumers. Open the appropriate fuse box . Detecti ...

© 2016-2026 Copyright www.vwpolo.net