VW Polo manuals

Volkswagen Polo Service & Repair Manual: Maintenance Test, Performing

  WARNING
Do not check or charge batteries that have a visual indicator that is bright yellow. Jump starting must not be used!
There is a risk of explosion during testing, charging or jump starting.
These batteries must be replaced.
–  Select “Maintenance Test”.
–  Connect the scanner.
  Note
If there is no scanner, manually enter the VIN on the printed test results.
–  Scan the VIN.
–  Select “at the battery pole” or “at the battery jump start terminal”.
–  Scan in the battery 2D code or manually select the type and manufacturer in the menu.
–  Measure the temperature. Hold the temperature sensor approximately 5 cm above the terminal connection until the temperature is stable.
–  Start the test.
–  Print out the test report if necessary.
   
Warranty Test, Performing
  WARNING Do not check or charge batteries that have a visual indicator that is bright yellow. Jump starting must not ...

Service Test, Performing
  Note The printed test results can differ depending on the software version. Read the Battery Tester -VAS6161- Operating In ...

Other materials:

Silicone Remover
Definition: Silicone Remover -LSW 019 000 A5-, watery Silicone Remover -LVM 020 000 A5- Silicone Remover, Long -LVM 020 100 A5- Edition 02/2012 S ...

Wiring Eyelets, Repairing
Special tools and workshop equipment required Torque Wrench 1331 5-50Nm -VAG1331-   Note Do not use rust remover, contact spray or grease because the lack of friction will cause the torque to be ...

Tread Depth, Measuring
  Note When measuring tread depth, take measurements in the main grooves. Do not take measurements at the tread wear indicator.     Tread depth of a tire must be mea ...

© 2016-2026 Copyright www.vwpolo.net