First read and observe the introductory information
and safety warnings
The vehicle has been manufactured specifically for a particular country and complies with the registration regulations that applied in that country at the time of vehicle production.
If the vehicle is to be sold in another country or used in another country for an extended period, the legal requirements applicable in that country must be observed.
In some cases, certain equipment will have to be fitted or removed and functions deactivated. The scope and type of service available may also be affected. This is particularly important if the vehicle is driven in another climate for a long period of time.
Because different frequency bands are used in different countries, the factory-fitted radio or navigation system may not work in other countries.

NOTICE
Information stickers and plates
Radio reception and aerialsTaper
Taper is caused by slightly offsetting the tread and/or the
belt by a few tenths of a millimeter from the geometric center
of the tire. Taper cannot be recognized visually nor can it be
measured with workshop equipment.
...
Checking with Expansion Valve and Receiver/Dryer, with Internally Regulated
A/C Compressor
Note
Connecting service station. Refer to
→ Chapter „Connecting Service Station“.
Observe test requirements. Refer to
→ Chapter „Pressures, Checking“.
–
...
Information stickers and plates
First read and observe the introductory information
and safety warningsSafety certificates, stickers and plates showing important
vehicle operation information are factory-fitted in the engine compartment and on
certain parts such as the tank flap, front passenger sun visor, the driver door
...