Volkswagen Polo Owners Manual: Indicator lamp
First read and observe the introductory information
and safety warnings
The central locking system indicator lamp is located in the driver door .
Depending on the vehicle equipment level, the vehicle may have an anti-theft alarm and a SAFELOCK mechanism .
| After locking the vehicle | Meaning | |
|---|---|---|
| Without anti-theft alarm | With anti-theft alarm and SAFELOCK mechanism | |
| A red LED flashes for approximately 2 seconds, firstly at short intervals and then more slowly. | Vehicle is locked. | Vehicle is locked and SAFELOCK is activated. |
| A red LED flashes for approximately 2 seconds and then goes out. The light starts to flash again after approximately 30 seconds. | — | Vehicle is locked and SAFELOCK is deactivated. |
| A red LED flashes for approximately 2 seconds in short intervals. The lamp will then light up without interruption for approximately 30 seconds. | Fault in the locking system. Go to a qualified workshop. | Fault in the locking system. Go to a qualified workshop. |
NOTICE
Introduction
This chapter contains information on the following subjects:
→ Indicator lamp
→ Description of the central locking system
→ Locking and unlocking the vehicle from the outsi ...
Description of the central locking system
First read and observe the introductory information
and safety warnings
The central locking system enables you to lock and unlock all the doors, the
tailgate and tank flap from one central point: ...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ Warning and indicator lamps
→ Handbrake
→ Parking
→ Information on the brakes
→ Brake support systems
→ Switching the TCS on and off
→ Brake flu ...
Fold Corrosion Servicing Notes
Corrosion on the Fold Edges, for Instance on the Hood, Door
or also the Rear Lid
–
Remove the corroded areas with
→ Chapter „Pneumatic Brush Grinder Set -VAS6446-“ or
→ Chapter „Brush Grinder Set ...
Introduction
This chapter contains information on the following subjects:
→ Positive and earth jump lead connection points
→ How to start the engine using jump leads
If the engine fails to start because the vehicle battery is flat, the flat
battery can be connected to the battery of anothe ...
