Volkswagen Polo Owners Manual: Overview of the menu structure
First read and observe the introductory
information and safety warnings
- MFD (multifunction display)
- Driving time
- Current fuel consumption (Curr. fuel con.)
- Average fuel consumption (Av. consumption)
- Fuel range
- Distance
- Average speed
- Digital speed display
- Digital oil temperature display
- Speed warning function
- Audio ⇒ BookletRadio, or ⇒ BookletNavigation system,
- Navigation ⇒ BookletNavigation system,
- Telephone ⇒ BookletProvision for a mobile telephone,
- Veh. status
- Settings
- Language
- MFD data
- Driving time
- Current fuel consumption (Curr. fuel con.)
- Average fuel consumption (Av. consumption)
- Distance
- Average speed
- Digital speed display
- Digital oil temperature display
- Speed warning function
- Time
- Hours
- Minutes
- 24h mode
- Summer time
- Winter tyres
- active
- +10 km/h
- -10 km/h
- Units
- Temperature
- Consumption per journey
- Second speed display on/off
- Travel mode
- Service
- Information
- Reset
- Factory setting
Introduction
With the ignition switched on, the different display functions can be
accessed via the menus.
There are no buttons on the windscreen wiper lever in vehicles equipped with
a multifunction steerin ...
Using the menus in the instrument cluster
Fig. 13 Vehicles without multifunction
steering wheel: press button ① in the windscreen wiper lever to confirm the menu
point and rocker switch ② to change the menu
Fig. 14 Vehicles with mul ...
Other materials:
Warning and indicator lamps
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
Handbrake is applied.
Release the handbrake .
Brake system fault.
Do not drive on!
Obtain profe ...
Lifting the vehicle with the jack
Fig. 168 Jacking points for the
vehicle jack (mirrored on the right-hand side of the vehicle)
Fig. 169 Vehicle jack at the rear
left-hand side of the vehicle
First read and observe the introductory
information and safety warnings
The jack may be applied only at the jacking points shown (m ...
CAN Bus Wires, Repairing
Unshielded two-strand wiring -1-
and -2- with a cross section of
0.35 mm2 or 0.5 mm2
can be used as CAN bus wiring.
The color coding of CAN bus wires can be found in the
following table:
...
