First read and observe the introductory information
and safety warnings
| Lit up | Possible cause | Solution |
|---|---|---|
|
Engine oil level is too low. | Switch off the engine. Check the engine oil level . |
| Flashes | Possible cause | Solution |
|---|---|---|
|
Engine oil pressure is too low. |
Do not drive on! Switch off the engine. Check the engine oil level. – Do not drive on or remain at idling speed if the warning lamp is flashing, even if the engine oil level is correct. The engine could otherwise be damaged. Seek expert assistance. |
|
Fault in the engine oil system. | Go to a qualified workshop. The engine oil sensor should be checked. |
Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.

WARNING

NOTICE
Introduction
Engine oil specificationTwo-Part HS Hardener
Definition:
Two-Part HS Hardener -LHA 009 041 A3-
Two-Part HS Hardener, Short -LHA 021 004 A3-
Two-Part HS Hardener, Extra Short -LHA 009 046 A2-
Two-Part HS Hard ...
Special Tools
Special tools and workshop equipment
required
Torque Wrench 1331 5-50Nm -VAG1331-
Crimping Pliers, Complete -VAS1978/1A-
...
Joint-Free Wiper Blade Characteristics
Characteristics for Bosch and Federal Mogul
Check the manufacturer when replacing the wiper blades.
Always replace them with blades made by the same manufacturer.
The wiper blades can be identified by the wiper arm mount.
...