Volkswagen Polo Owners Manual: In the engine compartment
- Preparation for working in the engine compartment
- Introduction
- Preparing the vehicle for working in the engine compartment
- Checklist
- Opening and closing the bonnet
- Engine oil
- Introduction
- Warning and indicator lamps
- Engine oil specification
- Checking the engine oil level and refilling engine oil
- Checklist
- Engine oil consumption
- Changing engine oil
- Coolant
- Introduction
- Warning lamp and coolant temperature display
- Coolant specification
- Checking the coolant level and refilling coolant
- Vehicle battery
Autogas
Fig. 133 In the upper section of the centre
console: switch for Autogas
First read and observe the introductory information
and safety warnings When the vehicle is restarted, the last
manual ...
Other materials:
Wheel, Balancing with Fine Balancing Machine (Finish Balancer)
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
Flat Connector Systems
Note
If necessary, housing securing mechanisms (secondary locks)
must be released or removed using specified tool before
releasing the contacts. Refer to
→ Chapter „Secondary Lock“.
...
Decorative Trims, Replacing, Bonded Decorative Trims
Special tools and workshop equipment
required
Cartridge Gun -VAG1628-
Trim Removal Wedge -3409-
Wiring Harness Repair Set - Hot Air Blower -VAS1978/14A-
Materials ...
